Buy the Retro Shift Plate - $19 $15 USD
Details
- 20mm by 30mm wide, 1mm thick.
- Many shift patterns to suit your car.
- Can be drilled and screwed into place or installed with double sided tape.
- Water jet-cut aluminum plate and brushed metal vinyl.
- Shipping calculated at checkout.

More than just a little plate. Each kit lets you either drill and mount the plate with the included tiny button-head capscrews
or you can glue on the capscrew heads and install with the 3M mounting tape.

There's enough tape included to remove and install the plate a couple of times. Just cut a small square and stick it on.

The plates themselves are precision water jet cut 1mm aluminum. The shift pattern is a diecut sticker printed on special brushed
aluminum material. This is the same stuff Mazda used from the factory to print the NA and NB Miata door sill inserts (that say Miata or Roadster).
Installed

The plates are 20mm (.78") by 30mm (1.18") wide. That's pretty small and allows you to fit the plate nearly anywhere.

It fits perfectly on the right side of an NB center console.

For those without the factory steering wheel, there's lots of room on the plastic hub cover.

The left side of the console has a ton of room, but with the hand brake down, you can't see the shift plate.

The plate isn't curved, but it can easily mount on a curved surface with the included 3M mounting tape.

You can even stash it down low. These little plates fit nearly anywhere.
About These Plates
The Retro Shift Plates are made by me, Adam of revlimiter LLC. I get the metal pieces cut in large batches and can always print more
shift patterns. We own all of our own machinery at revlimiter (well, not the water jet) and can always make a short run to fit your
unique car. If these plates are sold out, it's only a short wait until more can be water-jetted for you.
Site Navigation
Latest Blog Posts
Where’s all the blog posts?!?!
Posted on Fri, 27 Jun 2025 19:59:51 +0000
Why are you seeing 2013 blog posts in the "new posts" list? It's been a hard month for the revlimiter site.
Read more...
Mabel
Posted on Sat, 29 Jun 2024 03:42:43 +0000
Who’s the dog that keeps showing up on the revlimiter Instagram? It’s Mabel, my ACD/Pomeranian service dog.
Read more...
CarbonMiata Vent Window Install/Review
Posted on Sun, 29 Jan 2023 14:57:01 +0000
After waiting 23 years, there’s finally a pretty vent window kit on the market for the NA/NB Miata. Unfortunately, it doesn’t actually work well.
Read more...
NA Miata Ignition Switch Replacement / Refurbish
Posted on Fri, 12 Mar 2021 19:25:57 +0000
Is your NA Miata not starting anymore? A bad ignition switch may be the problem.
Read more...
XIDA ND Suspension Install
Posted on Mon, 20 May 2019 20:01:01 +0000
Mona dumps the soft GT suspension in favor of a set of XIDAs from Supermiata.
Read more...
[ © 1998-2025
revlimiter.net LLC |
Terms of Use |
Privacy Policy ]
Products sold on this site are for Off-road and Competition use only. This website intended solely to provide general guidance on matters
of interest for the personal use of the Reader of this Page, who accepts full responsibility for its use. All products
as well as information provided "as is," with no guarantee of completeness, accuracy, or timeliness, and without
warranty of any kind, express or implied, including, but not limited to, the warranties of performance, merchantability,
and fitness for a particular purpose.