February 7th, 2012 — Engine, Turbo

Yet more cooling system upgrades and tweaks. Thought I was all finished with my coolant reroute? Nah. I’d barely scratched the surface.
June 16th, 2011 — Engine, Turbo, Wrench Turning

The last in my series of technical posts dealing with changing out the head gasket. Everything you ever wanted to know about ARP head studs. It’s pretty awesome.
June 9th, 2011 — DIY, Engine, Turbo

Part TWO of Sharka’s coolant re-route! There are very few toy photos, but that’s the only deficiency in this post. 18 more coolant re-route photos round out this DIY project. Take a peek.
June 8th, 2011 — Engine, Wrench Turning

So, there I was. Standing in my garage, tired and hot. But I had my keys in hand for the first time in a while and was ready to start Sharka’s engine with the new head gasket, new coolant re-route, and ported head. I pressurized the fuel rail and checked for leaks…

Part one of Sharka’s coolant re-route. There was just too many photos to get everything into one blog post. And there was this little ninja who threatened me if I didn’t put this up right away…
May 1st, 2011 — Engine

My head is back from machining and in my lightbox. Nothing revolutionary or earth-shattering was done to the head, but I do expect a little more flow out of it. Take a look.
April 20th, 2011 — Engine
April 17th, 2011 — Engine
March 29th, 2011 — Engine

So there I was, sitting at a traffic light on the quiet side of an intersection. I’d just had dinner with my buddy Stoly (not at Taco Bell, at a much nicer nearby tavern) and was ready to go home and kick back. And…. THUD.